Image: Peter Fazekas / Pexels
Your Holy Stone HS720G powers on, but the motors won’t start, or it starts and won’t lift off. With a GPS drone like this, it’s almost always one of four things: the controller isn’t paired, the drone hasn’t finished starting up, the compass needs calibrating, or the battery is low.
This guide is for people who already own an HS720G. Here’s how to check each one, using Holy Stone’s own HS720G manual.
Last checked: 19 October 2026, against the Holy Stone HS720G user manual and Holy Stone’s HS720G product page.
Quick answer
Switch the controller on first: hold the lock button and slide the power switch on (two beeps). Then switch the drone on, put it on a level surface, nose forward, and wait for a long beep. Give it about 25 seconds to start up. Wait for a solid green light, which means good GPS, then calibrate the compass, which Holy Stone recommends before each flight. Unlock with a short press of the red button. If it still won’t unlock and the rear light flashes, charge the battery.
Read the status light first
Holy Stone’s manual explains what the drone’s lights are telling you:
| Light | What it means |
|---|---|
| Flashing yellow quickly | Drone and controller aren’t connected |
| Solid yellow | Weak GPS signal |
| Solid green | Good GPS signal |
Check 1: pair the controller
Holy Stone says to pair the drone and the controller like this:
- Hold the lock button on the controller and slide the power switch on. The controller gives two beeps.
- Turn on the drone and put it on a level surface, nose facing forward.
- A long beep means pairing has worked.
Keep the drone level while it pairs and starts up.
Check 2: let it finish starting up
The manual says the drone needs about 25 seconds to initialise. Don’t move it or try to take off during this time.
Check 3: wait for GPS
GPS mode is on by default. If the light is solid yellow, the GPS signal is weak. Move to an open area, away from buildings and trees, and wait for solid green.
Check 4: calibrate the compass
A compass that needs calibrating can stop a GPS drone flying properly. Holy Stone’s manual sets out the steps. Holy Stone recommends calibrating before each flight.
How to calibrate, from Holy Stone’s manual:
- Push both sticks to the bottom right to start calibration.
- Rotate the drone horizontally three times.
- Then rotate it vertically three times.
Holy Stone’s HS720G FAQ says that with no or very weak GPS (fewer than 7 satellites), the last calibration step ends with a red front light and a green rear light. Calibrate in the open, away from metal, cars and your phone.
Check 5: unlock and take off the right way
- Unlock the motors with a short press of the red button.
- One-key take-off lifts the drone and hovers at about 5 ft (1.5 m).
If you press and hold the red button for 3 seconds, Holy Stone says it works as an emergency stop and the motors cut. It only works when the drone is within about 16 ft (5 m) high and 49 ft (15 m) away.
Check 6: charge the battery
Holy Stone’s troubleshooting table says that if the drone can’t be unlocked and the rear light is flashing, the battery is low and needs charging.
Check 7: use the app correctly
The HS720G connects to the Ophelia FLY app over the drone’s Wi-Fi, named “HolyStoneGIM-“ followed by numbers. Holy Stone’s FAQ says your phone needs 5 GHz Wi-Fi (802.11ac).
Still not taking off?
If none of these work, stop and contact Holy Stone’s European support at eu@holystone.com. The manual and app are on Holy Stone’s website.
UK rules for the HS720G
Holy Stone lists the HS720G at 377 g. It has a camera and weighs over 250 g, so the CAA requires a Flyer ID to fly it and an Operator ID for the person responsible for it. See our Flyer ID vs Operator ID guide.
At this weight, the CAA’s Drone Code says you must keep at least 50 m from uninvolved people and 150 m from residential, recreational, commercial and industrial areas. See where can I fly my drone in the UK? for the full rules.
Our Remote ID UK explainer covers whether Remote ID applies to your drone.
Frequently asked questions
Why won’t my HS720G take off?
Usually the controller isn’t paired, the drone hasn’t finished starting up, the compass needs calibrating, or the battery is low. Work through the checks above in order.
How do I pair the HS720G controller?
Switch the controller on first: hold the lock button while you slide the power switch on, and it gives two beeps. Then turn on the drone on a level surface, nose forward. A long beep means it’s paired.
What does a flashing yellow light mean on the HS720G?
Holy Stone says it means the drone and controller aren’t connected.
How do I calibrate the HS720G compass?
Push both sticks to the bottom right, then rotate the drone horizontally three times and vertically three times.
Do I need to register a Holy Stone HS720G?
Yes. At 377 g with a camera, you need a Flyer ID and an Operator ID.
Keep reading
- Holy Stone HS720G help hub
- Flyer ID vs Operator ID
- Where can I fly my drone in the UK?
- All help and fixes
This guide is general information based on Holy Stone’s published instructions, not legal advice.
Sources (checked 19 October 2026)
- Holy Stone HS720G user manual (PDF): status lights, pairing, initialisation, GPS mode, compass calibration, unlocking, one-key take-off, emergency stop, troubleshooting, Ophelia FLY app, weight, support contact. static.holystone.com HS720G manual
- Holy Stone HS720G product page and FAQ: 26 minutes per battery, GPS and GLONASS, compass calibration before each flight, the weak GPS calibration result, 5 GHz Wi-Fi (802.11ac) phones. holystone.com
- CAA, Registering to fly drones and model aircraft. caa.co.uk registering
- CAA, Drone Code, Where you can fly (points 3 to 9). caa.co.uk Drone Code



